45.25 Shell Scripts On-the-Fly from Standard Input

Warning!	The shell can read commands from its standard input or from a file. To run a series of commands that can change, you may want to use one program to create the command lines automatically - and pipe that program's output to a shell, which will run those "automatic" commands.

Here's an example. [3] You want to copy files from a subdirectory and all its subdirectories into a single directory. The filenames in the destination directory can't conflict; no two files can have the same name. An easy way to name the copies is to replace each slash ( / ) in the file's relative pathname with a minus sign ( - ). [4] For instance, the file named lib/glob/aprog.c would be copied to a file named lib-glob-aprog.c . You can use sed ( 34.1 ) to convert the filenames and output cp commands like these:

[3] This isn't recommended for systems with a 14-character filename limit.

[4] A replacement like CTRL-a would make unique filenames (but ones that are harder to type).

cp 

from

/lib/glob/aprog.c 

to

/lib-glob-aprog.c cp 

from

/lib/glob/aprog.h 

to

/lib-glob-aprog.h     
...

However, an even better solution can be developed using nawk ( 33.12 ) . The following example uses find ( 17.1 ) to make a list of pathnames, one per line, in and below the copyfrom directory. Next it runs nawk to create the destination file pathnames (like to /lib-glob-aprog.c ) and write the completed command lines to the standard output. The shell reads the command lines from its standard input, through the pipe.

This example is in a script file because it's a little long to type at a prompt. But you can type commands like these at a prompt, too, if you want to:

#!/bin/sh find copyfrom -type f -print | nawk '{ out = $0 gsub("/", "-", out) sub("^copyfrom-", "copyto/", out) print "cp", $0, out }' | sh

If you change the last line to sh -v , the shell's verbose option ( 46.1 ) will show each command line before executing it. If the last line has sh -e , the shell will quit immediately after any command returns a non-zero exit status ( 44.7 ) - that might happen, for instance, if the disk fills up and cp can't make the copy.